subject
Engineering, 02.12.2019 19:20 laneake96

Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 minutes to perform the drilling operation using high pressure fluid delivery of coolant to the drill point. the current spindle speed = 4000 rev/min, and feed = 0.0017 in/rev. in order to improve the

surface finish in the hole, it has been decided to increase the speed by 20% and decrease the feed

by 25%. how long will it take to perform the operation at the new cutting conditions?

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 12:20
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
question
Engineering, 03.07.2019 12:20
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
question
Engineering, 03.07.2019 12:30
Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?
Answers: 3
question
Engineering, 03.07.2019 21:35
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
You know the right answer?
Agundrilling operation is used to drill a 9/64-in diameter hole to a certain depth. it takes 4.5 min...
Questions
question
Mathematics, 16.04.2017 18:34
Questions on the website: 6616171